How it work
This example will show you how to tract and display the switch state. It will show you when the switch is pressed and released.
Requirement
- Arduino or Genuino Board
- A momentary switch, button, toggle switch or switch button
- 10k ohm resistor
- hook-up wires
- breadboard
Cuircuit
Code
// digital pin 2 has a pushbutton attached to it. Give it a name:int pushButton = 2;
// the setup routine runs once when you press reset:
void setup() {
// initialize serial communication at 9600 bits per second:
Serial.begin(9600);
Serial.begin(9600);
// make the pushbutton's pin an input:
pinMode(pushButton, INPUT);
}
// the loop routine runs over and over again forever:
void loop() {
// read the input pin:
pinMode(pushButton, INPUT);
}
// the loop routine runs over and over again forever:
void loop() {
// read the input pin:
int buttonState = digitalRead(pushButton);
// print out the state of the button:
Serial.println(buttonState);
Serial.println(buttonState);
delay(1); // delay in between reads for stability
}
}
No comments:
Write comments